nf1z
About
- Username
- nf1z
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Yes, probably not for most FDM, as the (current) expected accuracy is not greater than the bare hardware can provide. I don't know if there are many of your users that use Repetier for a CNC metal-working application, or the laser-cutting I see in …
-
Thanks. Pitch error compensation is basically a table of errors versus axis positions. It is used to compensate for varying pitch of the leadscrew, rather than a constant pitch error (though it would handle that as a special case). LinuxCNC store…
-
Thanks for the (as always) very speedy reply. Not sure how you do it ;-) I do in fact have a RADDS/Due setup, RAMPS did not seem able to handle the CORE XY when I tried it, can't remember exactly why. The V2 is new to me: is it available and whe…
-
I guess that would be 0.005mm skipped at each probeSorry, I try to see if it's known first, but I missed that one. I tried the dev version and found that in the middle of the Z carriage that there is now no apparent drift of the Z axis, so good, t…
-
Further info: G29 S1 does a similar thing. The difference from G32 S2 is that it did this also in the previous version ((I made a note about it in November 2016). I also noted that the Z value displayed on the LCD when going slowly to Zmax is 647…
-
I ended up using a fresh image (mostly due to my slowness in appreciating the baud rate was wrong - see my other recent post), so I can't say whether the printing was affected for the upgrade case. I doubt it. I was about to say that I have upload…