› ›

AlejoTronica

About

Username
AlejoTronica
Joined
Visits
1
Last Active
Roles
Member

Comments

  • I found the problem, It was mechanical after all, The problem was the z axis, this printer only has one screw in Z, so when the Z axis moves, at first the screw only rise the right side and the left side only moves a little bit, aparently the error …
    in First ten layers at wrong height Comment by AlejoTronica June 2018
  • When I run G33 R0, the machine return uknown command, but the defaults in the software are this ones: There is something that I can try with this to maybe correct the distortion? Thanks in advance for all your help
    in First ten layers at wrong height Comment by AlejoTronica June 2018
  • Hello, I was outside town since last week. Roko said: @Repetier Could distortion correction  DISTORTION_START_DEGRADE,   DISTORTION_END_HEIGHT,   DISTORTION_LIMIT_TO,  affect this? I never touch this parameters Repetier said: @Ro…
    in First ten layers at wrong height Comment by AlejoTronica June 2018
  • Repetier said: Strange thing. Do you have some equipment to measure heights of extruder. First I'd measure just by moving from home to 10mm and see if you get a 10mm change, then to 20 and 30 mm. Firmware will always use same number of steps …
    in First ten layers at wrong height Comment by AlejoTronica June 2018