The_Maschinist
About
- Username
- The_Maschinist
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Mich beschleicht so ein Gefühl, daß mit einer anderen Lösung als Zurücksetzten sehr weit ins "Hacking" gehen würde und man damit Schindluder betreiben könnte außerhalb der Repetier Raspberry Pi Distribution. Sehe ich das Richtig?
-
Hallo, Wie gehe ich vor, wenn ich anno dazumal die ssh Anmeldedaten pi,rasbperry geändert habe? Kann mich nicht mehr an das Passwort erinnern. Den Anmeldenamen weiß ich noch. Vielen Dank im voraus.
-
YAY! I found a solution... I just killed Repetier-Firmware from my Eeeprom and installed so called "Marlin" Firmware. Ill leave this forum now. Byebye
-
Okay, got ya. But still cant find the issue. I use a RAMPS 1.4 wit a controller fan extender on the servo pins. Them also not running but I think this is an issue for another topic. This is the first Repetier Firmware I got running. Its a van…
-
Okay, first i deactivated line 310 #define ENDSTOP_Z_BACK_ON_HOME 0. It issued a so called: "Compilation error: 'DIOFAN2_PIN_WPORT' was not declared in this scope" Not sure that cause the pullup issue, but then I ask myself what does the error will…
-
Again, it detects the Endstop first and after it lift up once it goes way down into the endstop again endless. It completly lost it function. It raises after first time enough to release the trigger. Where is the problem to solve? Regards
-
Sorry, I understand nothing. I didnt found any useful settings in Eeprom.ccp nor in Eeprom.h.