Zythum

Comments

• I fond it! Into configuration.h, the EXT0_ENABLE_ON was egual to 1 and the EXT1_ENABLE_ON was equal to 0. I replace the EXT0_ENABLE_ON to 0 and now it's working! Thank for your help

  in 2nd extruder work fine, 1st don't extrude. Comment by Zythum October 2019
• Hi!  Thank again for the the reply. Before I try to extrude, I make sure both extruder are at 190°C. This is the EEPROM config I use. I can't find what's worng with Extr 1. Thank four your help.

  in 2nd extruder work fine, 1st don't extrude. Comment by Zythum September 2019
• Hi! You mean in pins.h /* original configuration for motherboard 39#define ORIG_E0_STEP_PIN         26#define ORIG_E0_DIR_PIN          28#define ORIG_E0_ENABLE_PIN       24 #define ORIG_E1_STEP_PIN         36#define ORIG_E1_DIR_PIN          34#defi…

  in 2nd extruder work fine, 1st don't extrude. Comment by Zythum September 2019
• Look like this fix the issues; G28 X0 Y0;G32 S1; Thank

  in Z Probing issues Comment by Zythum September 2019