yodor
About
- Username
- yodor
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
I've switched to 1.0.1dev branch and now things are better. also followed @alexsomesan Configuration.h as listed here https://forum.repetier.com/discussion/4893/bl-touch-z-probing-issues Thanks
-
After looking around bit more I've found more information about this issue. Seems marlinfw have had this issue too when endstops are checked in polling mode. Suggested cure is to enable ENDSTOP_INTERRUPTS_FEATURE. Does repetier have such thing too ?
-
I've recorded a video at 60fps where is clearly visible the probe when doing G29 and a scope showing the signal. Scale is at 5ms. It does do fine a G29 once (full 3 points) then on the second G29 when probe lower for first point you can see on scope…
-
Hello here is part of my Configuration.h related to z-probe and z-min endstop #define ENDSTOP_PULLUP_Z_MIN false#define ENDSTOP_Z_MIN_INVERTING false#define MIN_HARDWARE_ENDSTOP_Z true #define Z_PROBE_PIN ORIG_Z_MIN_PIN #define Z_PROBE_PULLUP 0#de…
-
yes I can understand that and is all fine. But is it not better if Repetier-Host trim/cut the filename to this exact size before sending to printer firmware. ?
-
I think is not problem with repetier-host. It suddenly started working normally. Possible just a mono integration issue. I'm on KDE but also installed GNOME packages and it started working fine. Thanks for your time.
-
I'm ok if there is error message because of the model is bigger than bed size. But problem is I can not close it. Clicking the 'ok' button does nothing. Can you elaborate more on the 'linux workaround for mono'. I was googling for some fix but found…
-
After renaming the STL file and re-slicing the warning error message is gone
-
Some more details, I'm on ArchLinux with latest updates, I have also tried to use the unpacked AppImage contents, and use the system installed mono version but it happens again. It seems the dialog can not be disposed properly and return to the main…
-
Yes I have not tested other error message boxes (as I dont have any other errors but when I try to put two or three objects and they are bigger then bed size, I have to scale them down, and then bam the message pops up which I can not close. Will b…