alesbedac
About
- Username
- alesbedac
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
And while i tried to manual switch the extruder heater in Rep. Host 2.0.5 with fw marlin V1 then it is possible. Result RpH 2.05 is not working properly with RpFw 11.0.2 I atached my Arduino Project. Which is configured for K8200, you can check it…
-
And i burned back the Marlin V1 FW. Because in repetier was unstable with the extruder heater sensor. About every one hour failed printing
-
Manual extruder heater solved, i went back to version 2.0.2 from 2.0.5. Now i am able to manual switch extruder heater and change the temperature. On tyhe same FW.
-
So, testes on Repetier server web page, there is automatic mode running roperly. ..firmware is also in dry run s... Where is in the firmware option to disable dry run mode? Atached image from automatic (printing) mode.
-
I have Board K8200 and i am not able to execute heater in manual mode via heater button. The extruder heater icon is "strangled". When i run the print (automatic mode) then the extruder heater is switched off when the target temperature (for example…