tildesign
About
- Username
- tildesign
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
I have had success doing this. The first time I failed, as I had formatted the USB stick as fat32, which didn't allow for any Unix permissions and such completely hosed the install. I set the server up again, this time formatting the stick as ext3 …
-
Thanks I'll give that a go. I assume if I used a symlink or something, the "disk free" bar graph in the web interface wouldn't work properly?
-
OK now I've just posted something, I think I know what the problem is. For some reason the auto setup reported the max XY speed and max Z speed for print time calculation as 1 mm/sec - and not the 250 (for XY) and 4 (for Z) that was actually set in …
-
Hmm this question is now a bit more academic as after thinking about my printer's intended workflow, homing to Zmax is the most sensible approach in all cases. In this case I can just issue a command to home Z at the end of the print and my intended…
-
I am also having trouble with SD cards. I am using a Due + Smart RAMPS + AZSMZ 12864 LCD/SD board and it was working fine on my old 0.92 setup. It detects that an SD card has been inserted/removed, but it doesn't show anything on the file list.