laspiros
About
- Username
- laspiros
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Yes after I rename the files it worked fine. I think the file names were too long.
-
I'm not sure which inputs do you mean for heatbed. Heatbed is working normal. It reaches my set tempersture (54oC). How do I find line 16? The last lines of log here: 15:39:12.433 : Resend: N28 G90*4215:39:12.442 : Error:expected line 16 got 1815…
-
Hi again, So I have updated my firmware to the latest one, I have set z probing and everything works smoothly. I also print some objects very good. At this point I have a strange communication problem and I don't know if I should start a new topic …
-
Yup! once again that worked! Really thank you! Do you mean to update to firmware 1.0 right? I suppose I can upload my fixed configuration file and update it to the newest right?
-
Yes that worked for me thank you. After a long day with configurating, testing etc I have everything almost done, except autoleveling bed. I followed the instructions of z probing, although some points werent perfectly clear for me, and I sent a G3…
-
Nice! same problem as described! Solved as described!
-
Yes I know. I have connected the fan directly on 12VDC for now and later I will fix that. I also saw that there are some extention boards for extra fans. I have connected my 2nd extruder to D9 instead of fan. How can I make this D9 output to control…
-
RAyWB you are the best!!!! Your tips were really helpful! I tryed again the configuration tool (by the way it is very helpful) and I put the settings that I have tested so far. The only problem I have now is with my second extruder heater. To heat…
-
I fixed that! I didn't read carefully the part you said : "if you move z+ direction and it moves away from extruders its ok,otherwise set #define INVERT_Z_DIR 1 Sorry about that. Now it homes fine but when I press Z+ from host my bed moves downwar…
-
Sorry I forgot to mention I fixed the sensor triggering by changing #define MIN_HARDWARE_ENDSTOP_Z from true to false and again when I home Z my bed goes downwards.
-
I did what you told me and also connected the proximity sensor to Zmin pin on the raps 1.4 board. Now I can move the bed normally, with z+ goes upwards and with z- goes downwards. But when I home Z it moves a little bit upwards and stops which i…
-
MartinH is located near the extruder. Is a proximity sensor. RAyWB yes this is the machine I build a copy of. I am not sure what exactly do you mean. I know that ( in general) the Zmin is the lowest point that a bed can reach and the Zmax the h…
-
Thanks for the eply Roko! All of them shows L when they are opened and H when they are triggered. I tryed #define ENDSTOP_Z_MAX_INVERTING false, but then when I home Z, bed moves downwards a bit and then stops. I also changed the status of the sof…