Andy1205

Comments

• Hi again - thank you very much!  I enabled ftp and it works now.  I appreciate your support.

  in Can you control the M3D ProMega with Repetier Server? Comment by Andy1205 July 2019
• Thank you. I'll have a look.

  in Can you control the M3D ProMega with Repetier Server? Comment by Andy1205 July 2019
• I think I might have been silly - I have just seen the ‘add new printer’ option....

  in Using Repetier with two printers and CuraEngine Comment by Andy1205 July 2019
• Hi - I am sorry - I am using Windows and just can't get it to work.  I have the IP address and RepRapFirmware selected but Repetier server on a Raspberry Pi can not connect.  Please can you help to explain how to find the port?

  in Can you control the M3D ProMega with Repetier Server? Comment by Andy1205 July 2019
• Great. So which ports etc sounds I use?

  in Can you control the M3D ProMega with Repetier Server? Comment by Andy1205 July 2019
• Hi Thanks for the quick reply. It says it uses Open Duet 3D printer control board, source electronics, firmware and software Andrew

  in Can you control the M3D ProMega with Repetier Server? Comment by Andy1205 July 2019
• Hi I am afraid I don't know.  How can i tell?  They say you have to use their own software - https://printm3d.com/themicro/  Andrew

  in Compatibility with M3D Micro - original Comment by Andy1205 April 2018
• Thank you - I am glad I checked first!  Please can you advise where I might find the configuration file for the printer?  When I got it I just added it to Repetier Server and it seemed to work but not perfectly.

  in Noob: Firmware for 3DR Delta and Autolevelling Comment by Andy1205 April 2018