hen3bosch
About
- Username
- hen3bosch
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Ohm said: Hope it helps! Yes, Thank you, I'm finally getting some understanding in what to do. It seems that I was looking in the wrong places. Thank you again! With kind regards, Hendrie
-
Ohm said: So after some trial and error, I now understand my error - I had set the coordinates thinking the machine would add the probe offset, but it does not. Entering the numbers I calculated in my previous post got it probing exactly wher…
-
I'm sorry, the errors i'm getting are for code G32 but it's the same error and problem not knowing how/where to fix it. With kind regard, Hendrie
-
Repetier said: That means you tried to move outside the reachable area. Typical reason for G33 is that the tested area is a rectangle coving the whole circle whcih leads to test points outside. Select exclude corners and select a rectangle o…