fobetor

About

Username: fobetor
Joined: April 2018
Visits: 1
Last Active: April 2018
Roles: Member

Comments

Hello Where do I set the preheat temp to 0? On the other hand... It does not work. I have plugged the sensor to the Zmin, and assigned the z probe pin to the z min pin. Then, when I tell the printer to home Z, It homes X, Y, and beging moving z i…

in Bltouch z probe as z min endstop Comment by fobetor April 2018
Thanks, I will try your instructions. regards

in Bltouch z probe as z min endstop Comment by fobetor April 2018