› ›

ch4d15

About

Username
ch4d15
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Yesterday i tried and the tower angles are correct as it is default, the diagonals i must correct to get the acurracy and the perfect square (its a little bit off) 
    in How do I use Delta Correction? Comment by ch4d15 March 2018
  • So if i get it right i must adjust the angles reset the autolevel and calibrate it new to get it working? Or can i mehanicly adjust the angle so that i lengthen the one side of the delta?
    in How do I use Delta Correction? Comment by ch4d15 March 2018
  • Repetier said: Ok I have read the instructions and adaption is quite simple - even easier then in Marlin:-)In EEPROM you see the 3 delta tower angles which are normally 120° apart. Simply change these values like you would change the degr…
    in How do I use Delta Correction? Comment by ch4d15 March 2018