› ›

CALIISCOOL

About

Username
CALIISCOOL
Joined
Visits
3
Last Active
Roles
Member

Comments

  • i figured out the problem. i was using thermocouple pin. it does not support thermistors i did not see a thermistor pin in the selection on the configuration tool but with research i found out that i could use Analog pin 13 for thermistor 0…
    in fatal: Heater/sensor error Comment by CALIISCOOL April 2018
  • No additional information in log only (fatal: Heater/sensor error.) all pins are correctly assigned it will not begin to print unless everything is exact. Thermocouple/Thermistor reads constant temperature of around 238 degrees C WHEN COOL i have tr…
    in fatal: Heater/sensor error Comment by CALIISCOOL April 2018