- Last Active
CarlJonas said: BUT i can't use the SD Port anymore. If your are using SPI for the TMC's you can't use the SD-Card feature anymore. As far as I know the SAM3X8E on your DUE board does not support SPI cascading.
@alexsomesan I soldered the pinheader to the top side. I had no problems so far. I'm running my workhorse on TMC2130 for weeks now. My setup looks similar to your photos. The only issue is that I have to reconnect repetier server (reset firmware)…
New challenge: I want to activate sensorless homing. My idea is to use only one motor for both X and Y. I have a CoreXY and when I home X or Y both motors run and stall at the end. I configured XMAX_ENDSTOP and YMAX_ENDSTOP to X_MAX_PIN. Homing X wo…
Virtualchronos said: alexsomesan said: @Virtualchronos and @PioniSensei did you make any adjustments to the potentiometer on the step-sticks. If I understood things correctly, to have access to the entire range of current settings via…
@alexsomesan I bought the first best result on german eBay from StepperOnline (2.0A; 46Ncm; 1.4ohms Resistance; 3.0mH Inductance). Is the following "wiring scheme" correct? The Radds and the BoostConverter will have common ground.
I have a CoreXY printer and installed TMC2130 drivers for XY and Extruder on my RADDS board. Thank you for your hard work. So far everything works "ok". I still have some issues in stealthchop mode with diagonal moves (only one motor moves). The hol…