TheBori

Comments

• Thanks, Any recommendations on the retraction settings?  The DQ swirl is the little loop of ice cream you see at the top of the cone.

  in Retraction Settings when Using Cura Comment by TheBori July 2018
• Can I get a mini-lesson in retraction? When my extruder changes position (i.e. moves to a second shape or to the other side of the current shape) it drags a thread across the object.  This is usually not a problem since the thread is thin.  Occasion…

  in Retraction Settings when Using Cura Comment by TheBori July 2018
• Is it necessary to "repair" these shapes?  In some cases, I don't want the shape to hold water.

  in Non manifolded object repair Comment by TheBori July 2018
• Yes...when I had the hot end and motor separated I supported (for safety) and heated the hot end assembly well above 150 (step 6).  The motor does move (chatter) in that arrangement...just not continuously in one direction.  Thanks for the override …

  in Extruder motor chatters, spins perfectly using other motor control Comment by TheBori April 2018