gok4pa
About
- Username
- gok4pa
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
I was just scrolling through the code at the bottom. I found 3 lines in red. Error: No Line Number with checksum, Last Line:0 Error: Line Number is not Last Line Number+1, Last Line: 0 Resend: 1 (then it says) ok Resend: N1 M110*34 Resend: N2 M115*3…
-
This is only a recent problem. I checked all my wires and connections. Just changed my usb cable today. It has stopped 3 different times on my cut. Wasted 3 pieces of wood now. Is there anyway to start back from where it aborts? The rough cut is 3hr…