› ›

steveKimpton

About

Username
steveKimpton
Joined
Visits
3
Last Active
Roles
Member

Comments

  • Thanks for your comment.  On re reading the discussion above, I realise that although my problem is superficially similar to josharchibal's the cause is obviously different and is only caused by the excessive Z axis speed. I don't know how to chang…
    in printer starts printing too high (1-2 mm) Comment by steveKimpton July 2020
  • I now have a similar problem on a Geeetech i3 but it has previously worked fine for a couple of years.  The Repetier generated code always includes these lines near the start: G1 Z5 F5000 ; lift nozzle ... ... G1 Z0.300 F7800.000 If I change these…
    in printer starts printing too high (1-2 mm) Comment by steveKimpton July 2020
  • Ahh - sorted.  It was a Freecad issue.   To export an object in STL format, you "Typically only need to select the last object at the at the bottom of the model tree".  I know from experience that it doesn't work if you select more than the last obj…
    in Object not appearing Comment by steveKimpton February 2018