PikoTing
About
- Username
- PikoTing
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Repetier said: Try disabling "Send ETA to printer display" in printer settings. I think that gets parsed wrong causing the error. Oh this time it really works !!!!! Really appreciate the help, finally can print without any problem. Thank…
-
Repetier said: You only show 30% of communication. For analysis always use the real log to a file or at least activate all log parts. Also always start with the good part so we can see how bad part evolves. From the messages it seems like fi…
-
Repetier said: drive min should not be the problem. Only the fact that you seem to not get over 25%. With high drive min you might get problems with lower tempertures. YOu now just force the high value also max is even higher and was no real …
-
Repetier said: That looks wrong. You have set pwm max values to 255 but even when heating is low it seems you are only using 25% of the power. Is this correct? If you set heat manager to 0 does it also limit to 25% power? There it uses PID ma…
-
Repetier said: That looks wrong. You have set pwm max values to 255 but even when heating is low it seems you are only using 25% of the power. Is this correct? If you set heat manager to 0 does it also limit to 25% power? There it uses PID ma…
-
RAyWB said: looks like 24V heater powered with 12V only. can you measure heaters resistance? for 40 Watts: 12V Heaters are around 3.6 Ohms 24V Heaters are around 14.4 Ohms Thanks for answering I don't have the equipment to measure but …
-
Thanks for answering . My drive max 255 already and still not getting to the temp here is my setting Repetier said: You see power does not get up as required. Typical reason is that drive max is still on 130/180in configuration limiting the …