› ›

Norminal

About

Username
Norminal
Joined
Visits
1
Last Active
Roles
Member

Comments

  • So if I understand you correctly, measure the voltage where the wires connect to the board and if it is 12V before I tell it to heat up, then it would be a heater problem, not the board? 
    in Decoupling Error Comment by Norminal January 2018
  • The log basically says the heater didn't heat up fast enough in a x amount of seconds. Which is true because usually, when the printer was working, the heater heated up pretty quickly (40 C in < 5-6 seconds) whereas now, the heater just stays at …
    in Decoupling Error Comment by Norminal January 2018