Geggusveckus
About
- Username
- Geggusveckus
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
Ash wonderful. Then many of the settings in online configurations can be changed later with different commands by sending them to printer? Or do I need to edit firmware source code, upload it try to print and then change and upload again?
-
Damn it is alot harder then i thought it would be to do the online configuration.. If someone could help me that would be amazing. I am stuck at second page of online configuration on stepper. with Delay stepper signal and Jerk XY moves. i have u…
-
I would love if someone had the config aswell, i have a Prusa i2 with some upgrades but it runs pretty mutch the same firmware settings except some small changes, If i find it i will post here
-
You get the missing parts for some older Arduino IDEs here: https://code.google.com/p/sanguino/downloads/list you should use Arduino 1.0.1 with sanguino. Unfortunately the official homepage seems to be sold and now someone else runs sanguino.cc whe…
-
I have already figured out that sanguinos are not supported. I havent figured out yet how to do that yet but i am trying to learn