erik23

Comments

• Hi, because it failed in compiling from git, I installed via debian package. Now, all works fine, even the extcommands for switching on or off the printer are workingOnly the shutdown and reboot does not do anything, nor helps my sweet workaround to…

  in Repetier Server 0.80 will not start on boot RPi3 Comment by erik23 January 2019
• better than moving to a defined place would be a relative one, especially for z.  I would like to see it moving just 10 mm lower. Though it makes things slightly more complicated --

  in Pause throws off X and Y Coordinates Comment by erik23 March 2018
• It is not a matter of avoiding the extra time in homing to zmax. It's about having a  hand-adjustable distance to the bed, in my case with a micrometer screw via adjustable ZMin Endstop.  It's very nice to have. The problem left is that you cannot …

  in Bed Correction with three motors - little error left Comment by erik23 March 2018
• in Bed Correction with three motors - little error left Comment by erik23 March 2018
• I've declared h1,h2,h3 just at the beginning of the text, making them global. So they have exactly the Z-Probe Distances from the first snipplet. The exakt Positions of the motors are not easy to tell, because the coordinates on the xy plane does …

  in Bed Correction with three motors - little error left Comment by erik23 March 2018
• May be the problem is caused because I do only one cycle at a time (but doing 3 times the G32 via starting script. I crawled into the source code, adding a maxdiff with "do no correction under 0.05 maxdiff" and multiplying the h2 and h3 - height co…

  in Bed Correction with three motors - little error left Comment by erik23 March 2018
• Well - I would hope for another solution. I have a newly set up Printer with three-Z-Motors for bed level correction, and it is almost perfekt. But I still want to home to zmin, because there is a micrometer screw to adjust bed Level Distance. I wo…

  in Homing Z with probe Comment by erik23 March 2018
• Question aimed more for the 3Motor - Autoleveling with 4 motors, but I already changed to a 4 Motor design imitating 3 Z Motors (two Motors synchron with a bar in between, bed attached to the middle of the bar). So I only have to manage the 3Z-Motor…

  in 3 singel controlled Z-Stepper Driver Comment by erik23 January 2018
• Strange, I tried for hours, but it is quite simple; found a wrong x-Length Entry in the EEPROM Settings. Was a bit to long, and that's it. All fixed and fine

  in First move 100mm longer after homing x max Comment by erik23 January 2018
• Hi, a year later now: are the 4 steppers for z already implemented? Any docs to read somewhere about this? (Radds)

  in 3 singel controlled Z-Stepper Driver Comment by erik23 January 2018