flydeprutten
About
- Username
- flydeprutten
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Sorry, no. I simply could not figure out what the problem was, and my bed is too uneven to avoid distortion correction. I worked with the problem over a few weeks, and tried, what I think was everything. That's why I eventually switched to another …
-
OK. I will try to optimize my z-probe to see if it helps. Thanks for the help.
-
Oh, but then I do not understand why my first layer looks like it does. Is it supposed to have those big differences in the first layer, that can be seen in the picture?
-
ahh. That makes a lot of sense. I've overlooked that part of the configuration. I presume it should be: #define DISTORTION_START_DEGRADE 0#define DISTORTION_END_HEIGHT 0 Thank you I've only set the z-probe height to 0 temporarily, as I'm still w…