373996214

About

Username
373996214
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Thank you RAyWB and Repetier.Now it works.  But a new problem comes out. Because the power of my laser is low, the powders cannot be sintered well. For this, I slowed down the speed of motors during printing. When the 2nd layer was printering, huge …
  • RAyWB said: seems you overlooked that laser only gets activated when moving. so the M3 command has to be followed by G1 command. for example: M3 G1 X100 Y100 F500 //here Laser is ON G0 X0 Y0 //here Laser is OFF Laser is only switched on d…
  • Repetier said: YOu can use the z man pin as output, but that does not mean you have to enable z max endstop. In fact, that is just what prevents it from being used correctly. Making it an endstop pin means setting it as input, while oyu need …
  • Repetier said: Firmware has 3 operations modes - M450 - Reports printer mode - M451 - Set printer mode to FFF - M452 - Set printer mode to laser - M453 - Set printer mode to CNCAnd if you have support compiled in these comm…
  • Repetier said: RAMPS has D9 for many functions like fan or second heater as well, so you probably have selected to have a fan so that will overwrite it. Are you sure your laser needs 12V from D9? My laser has power input plus a signal input …