› ›

Kiwi0ne

About

Username
Kiwi0ne
Joined
Visits
4
Last Active
Roles
Member

Comments

  • Hi there! Yes I am using 5.2.1 and  Thank you for your suggestions. Everything seems to be normal under speed. The values are taken from the firmware. I have changed 3d Printer and I have the same problem. If I slice via Ideamaker then the print ti…
    in Print times via Cura Comment by Kiwi0ne January 2023
  • HI there. This is for all views. Ran Top but don't see anything major as far as taking up CPU time. I'll try to turn off the webcam but I would really need that.
    in Repetier Server very slow Comment by Kiwi0ne March 2018
  • I am using the official Raspberry Pi 7" touchscreen display. It is attached to the raspberry Pi 3B+ via the flat cable it comes with. I am using an internal IP web address to access it. but again via PC is fine, but via the touchscreen is incredibly…
    in Repetier Server very slow Comment by Kiwi0ne March 2018
  • Repetier said: Yes, can happen if streamer software uses different header capitalization then expected. Seems like mjpg_streamer has changed this so that it does currently not work, but should work again on next release. We are working hard o…
    in Do not see video at Dashboard Comment by Kiwi0ne December 2017
  • Hi there!  Resurrecting this thread because I have the same issue.  I am running Repetier Server on a RPi3+B and using a Logitech C270. I can see the video and static images streaming in the configuration settings of the webcam, but not in the Webca…
    in Do not see video at Dashboard Comment by Kiwi0ne December 2017
  • Hi all,  I just downloaded Repetier Server for trial and ran into this problem on my Prusa i3Mk2.  Assessing if Repetier is a step up from Octoprint mainly for multiple printer management.  10:20:55.642: FIRMWARE_NAME:Marlin V1.0.2; Sprinter/grbl ma…
    in No functionality possible after update Prusa i3 mk2s FIRMWARE 3.1.0 Comment by Kiwi0ne December 2017