› ›

713

About

Username
713
Joined
Visits
0
Last Active
Roles
Member

Comments

  • So I tested every connector seems like they work fine and the connections are correct too, I also disconnected the ps from the board( on the board's end) and ps led remained on, how can I test it from here? Is my board somewhat broken? Edit: OK, I …
    in Problem with 3d printer receiving commands Comment by 713 December 2017
  • I tried disconnecting wires from ps to board and the led stayed on, so before doing anything stupid I want to be sure it's safe(for the board), are ground wires different? I mean does it make a difference if i switch their places? or maybe i should …
    in Problem with 3d printer receiving commands Comment by 713 December 2017
  • Roko said: Repetier said: Open log and see responses. If you can read temperatures from firmware the connection is not your problem. You have either not enabled power or you must send M80 to enable power if using an ATX power source. H…
    in Problem with 3d printer receiving commands Comment by 713 December 2017
  • Repetier said: Open log and see responses. If you can read temperatures from firmware the connection is not your problem. You have either not enabled power or you must send M80 to enable power if using an ATX power source. Hope you got a conf…
    in Problem with 3d printer receiving commands Comment by 713 December 2017