› ›

ertu

About

Username
ertu
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Repetier said: Use dev version, whcih has a special MKS board since it has one separate fan outpin so heater pin numbers are correct. Rest is the same so no reason for motors not to work. If you have set to move only after homing that might …
    in MKS v1.4 with TFT 2.8 and bltouch. Need help plz Comment by ertu December 2017
  • Thanks for your help. It was a firmware issue after flashing again problem solved But now another issue.. I have MKS tft 2.8 LCD display and i use Reprap full graphics display into firmware. I use a PI for repetier server too. When i power on the…
    in MKS v1.4 with TFT 2.8 and bltouch. Need help plz Comment by ertu December 2017