CarlJonas
About
- Username
- CarlJonas
- Joined
- Visits
- 14
- Last Active
- Roles
- Member
Comments
-
Okay, i found the problem. anable_on was activated because of the raps128 i used before. Now the Axis and Extruder Work fine. BUT i can't use the SD Port anymore. When i Stick into the radds Display, i get the Message that a sd cart was inserted but…
-
Hey guys, i also tried to get the 2130 work on my delta with radds but until now it does not work. I connect everything as it was mentioned in this thread. The problem is, that the axis doesn't move but the extruder motor is at a standstill. The int…
-
i understand. I use a radds board with arduino due. i will change the microstepping and try it again. thank you very much. next step is to buy some tmc 2130 with interpolation from 16 to 256 microsteps.
-
Thank you for the fast reply. I have 6500 steps/mm for the extruder. I only use L but the problem is, when i activate USE_ADVANCE the extruder doesn't move. Even not in the Filament change menu. So in the end, until now i wasn't able to use the adva…
-
Hi, i noticed the problem still exists. when linear advanced is activated the extruder doesn't turn, but i found out if i set the extrudersteps very low, the extruder turns. Is it possible that my setup need to much Steps to calculate? Best Regards
-
thx
-
I connected it to the analog pin on the long side of the radds board. And yes i use the e3d ampilfier. I found Out that i don't have stable 5v source, it has only 4,6 v. The solution is a little buck boost converter to get stable 5v. Now everything …
-
Thank you for the fast answer. I can't find that "switch" in extruder.cpp. What do i have to search for? I also can't find the table for the e3d temp table. best regards cai
-
Mhh but it isn't a mixing extruder. i use a y-joined like the prusa multimaterial upgrade.
-
Okey i have one nozzle and one heater. So i have time activate SHARED_HEATER and MIXING_EXTRUDER?
-
ok i understand, i tried another fan and that worked perfekt, looks like the two sunon in parallel doesn't work as they should
-
Hey, thank you very much for the fast reply. When i turned the fan to 100% it runs at full throttle, when I then switch it to 75% it stops turning. When i use the repetier host and set the fan speed to 90% it turns much slower, below 90% it doesn't …