› ›

Sazabi

About

Username
Sazabi
Joined
Visits
3
Last Active
Roles
Member

Comments

  • Repetier said: Engraving is not supported with our plugin. It only converts lines to moves. Also firmware does not natively support changing PWM for laser, that requires some modification of the setIntensity function to set a hardware pwm ins…
    in Problem with laser option Comment by Sazabi February 2018
  • Repetier said: Yes it does a sit now uses fan to control laser. Laser mode is better in that it controls exactly when laser is on and when not. Your way requires M106 for each change. Is it possible to use heatbed or extruder heater output…
    in Problem with laser option Comment by Sazabi February 2018
  • Actually, provided gcode works just fine, just small mod needed - no M452. Witthout activating laser mod, it engraves with no problem.
    in Problem with laser option Comment by Sazabi February 2018
  • Small addition. If I stay in FFF mode, gcode works.
    in Problem with laser option Comment by Sazabi February 2018
  • Moved z-probe lower, looks like it works.
    in Need help with Auto bed leveling. Comment by Sazabi October 2017
  • Thanks, that helped. Few more questions: - Tools-Bed height map makes Host to crash. Runing with 5*5 points. Crushes on about half way done. - Z_probe_height -1.000. I have inductive probe and alu table. When I try to home Z axis, it crushes into ta…
    in Need help with Auto bed leveling. Comment by Sazabi October 2017
  • Ok, I've flashed dev firmware. Left everything as it was, except homing procedure as was stated by MartinH. ZHOME_PRE_RAISE_DISTANCE is 10mm. While homing I get message in repetier, that  hotend is trying to reach unavailable coordinates (-20, -60 -…
    in Need help with Auto bed leveling. Comment by Sazabi October 2017
  • MartinH said: I run homing and bed levelling from the script option buttons, homing just send  G28 levelling, i like to make sure the sensor is over the bed before it starts ,so i set in button 2 G1 Z10 F700 G1 X30 Y30 F1200 G32 Can you …
    in Need help with Auto bed leveling. Comment by Sazabi October 2017
  • MartinH said: First, i recoend using the dev version of firmware, many improvements in probing . Use homing option z up X Y Z this will open a section in config tool where you can set the X Y coords for z homeing. setting ENDSTOP_Z_BACK_ON_H…
    in Need help with Auto bed leveling. Comment by Sazabi October 2017