RomanCota
About
- Username
- RomanCota
- Joined
- Visits
- 26
- Last Active
- Roles
- Member
Comments
-
Cleared EEPROM with Arduino IDE, uploaded Repetier Firmware again and all works like a charm sending G0 Z140 does work as intended now, also it seems that G33 still crashes on Z axis, was it changed to work only with Z-Min?, After sending G33 an Axi…
-
RAyWB said: Quote:"Y in software goes from 250 to 200, but Z axis keeps going down and has no intentions to stop, had to emergency stop, used G0 Z240 and did the same. "maybe you should post your configuration.h to see whats going wrong with…
-
Repetier said: z-max homing is in deed a good trick. Apart from never hitting an object you can set z length > height allowing to go everywhere and you can use G92 Z0 to set z=0 at any height. After homing chaneck M114 to see what firmwar…
-
After "G0 Z200", Y in software goes from 250 to 200, but Z axis keeps going down and has no intentions to stop, had to emergency stop, used G0 Z240 and did the same. Have a Z-Max switch and homing to it works fine. Manual Control works fine and does…
-
RAyWB said: change homing to ZMAX. procedure : Home z , Home x , home y , then probe . That´s the way it works for me Disabled "Z homing in negative direction direction (towards min endstop). (Z_HOME_DIR)" and configured Z max to be 250m…
-
Doesnt work still, Home X they Y and it seems like Z must be homed to be able to go into negative Z values, CNC model Goes from Z cero (top) to Z -19 (bottom of material), but in the CNC software it just parks at Z cero "0", this is so frustrating
-
Changed the Arduino Mega and suddenly all worked, made a EEPROM clear program for the other Arduino, swamped the rascals and all worked like a charm... Did a M502 and M500 before but it seems EEPROM just had a Gremlin. So getting back in the G30 H1…
-
Its on low, with a signal de-bouncer: 02:24:23.001 : endstops hit: x_min:L y_min:L z_min:L Z-probe state:L I home X, then Y, send a G30 H19 R2, does one probe, goes up and fatal:G30 probing failed. Back on 0.92 I could use ArtCAM without endstops …
-
Quick edit: G30 H19 R2 only gives "fatal:G30 probing failed"
-
First a quick image Would this be the correct way to look at the coordinate system in 3D printers?, since 3D printers go from buttom to top?, because the CNC software I use goes from top to bottom (ArtCAM), back in 0.92 Z Min was manually set using…
-
Gave G30 H19 R2 a try and after a single probe it trows an arror saying "Could not activate Z-Probe offset due to coordinate constraints", also in the Z min pin ant the probe pin do are separated. Am I missing other configs? I feel like I'm missin…
-
I did a test using the Dev build and soon after G32 S2, the z axis crashed into the bed, I had been using 0.92 before this, I'm used to clicking Emergency stop and manually position the cutting bit at my 0,0,0 and then hitting all the home button's,…
-
Firmware and EEPROM I use: https://drive.google.com/open?id=0B1uFOw8MyGjCU09UekNNSUtRbnM