Timppa71
About
- Username
- Timppa71
- Joined
- Visits
- 29
- Last Active
- Roles
- Member
Comments
-
Great, it worked! Thank you so much. This is what I was looking for, at the moment
-
By the way, should this filament runout sensor / printer pausing work also with "dry run"?
-
Ok, thanks allready. And yes, I use Repertier-Server, of course. So, I have to send M513 manually, right? Or if I use "change filament" -option under Rep-Server will it do this automatically?
-
No, it will work with a free version also
-
Yep, times sounds like I have, at the moment. Now my wlan0 is ready for 14 secs but approx. 50 second to full screen. It would be nice to speed up booting time somehow I will wait if you find something... I bet you will, someday, when you just have…
-
Well, I have to try move some of the wlan routers closer to Rep-Server sometimes and try it again. Until then I just have to wait a bit longer because I do not want to lose those options. Just to make sure, I must ask again: Will your Repertier-Ser…
-
Ok, thanks. I updated my Raspberry with a newest Raspberry Pi image and changed 5.0" screen to original 7.0" screen. Now I have booting time just over 10 seconds, if checked with sudo dmesg. But in real life booting to Repetier-Server will take almo…
-
Thanks! I got following: [ 0.000000] Booting Linux on physical CPU 0x0[ 0.000000] Linux version 4.14.80-v7+ (dc4@dc4-XPS13-9333) (gcc version 4.9.3 (crosstool-NG crosstool-ng-1.22.0-88-g8460611)) #1161 SMP Mon Nov 12 18:51:43 GMT 2018[ 0.…
-
Well, maybe there was some communication problem between Arduino and Raspberry. After reboot I manage to set extruder and save data. I did not try configuration wizard again...
-
I have exactly same issue? Long retraction and undo lenghts are set to 6mm but in real life filament is retracted about 40 to 50 mm's..? I hope that someone finds a solution/ explanation for this.
-
Update... I changed my Ramps + Arduino Mega combo and flashed newest Repetier firmware. And after this, emergency stop problem is gone. So, obviously there were something wrong with my old configuration
-
Ok, now I understand Thank you for your help.
-
I have three different "buttons" and those will control PWM output. Three different codes are: M42 P9 S153 to set LED's to 60% M42 P9 S85 to set LED's to 33% and M42 P9 S38 to set LED's to 15% Above Gcode commands will work all the time, I can see …
-
0.90.3 version has this improvement, great! And thanks a lot.
-
Yes, correct. My printer has this ATX power option (ATX pin) and it is controlled with commands M81 and M80, I think. Like it work even now in Repetier firmware and also in Repetier server... In meanwhile, maybe I can done this by means of external…
-
Ok, thanks for the info. It is not so big deal but I think that it would be more informative in 24h time format for european consumer...
-
With your help and support I finally got autoleveling and homing work properly. Thanks a lot! I change "Z up, X, Y preheat Z" to "X, Y preheat then Z" and homing starts to work.
-
Thanks. I use latest Repetier 1.0_dev FW already or what you mean with "version 1"? Yesterday evening I have some success with autolevel (I manage to set nozzle height correct) and prints are good. Problem is homing and homing position..? I probabl…