centerfix

Comments

• I do not fully understand, you can not give an example

  in diamond hot end extruder Comment by centerfix January 2018
• does that work when you print? because there are all 3 engines also when I'm printing

  in diamond hot end extruder Comment by centerfix January 2018
• Good to hear some who have the same problem as I have

  in diamond hot end extruder Comment by centerfix January 2018
• thanks

  in foglertech ft-5 Comment by centerfix October 2017
• I can not change that protection? .. should use it for my mks tft 3.2

  in foglertech ft-5 Comment by centerfix October 2017
• found out where the wire was wrong with ... but I would like to make a macro. where I move the filament 800 mm to my nose. it can not, can only move it 100 mm with g01 e100 f2000 have tried to write g01 e800 it does not work .. what do I do there?

  in foglertech ft-5 Comment by centerfix October 2017