kas

About

Username
kas
Joined
Visits
19
Last Active
Roles
Member

Comments

  •  >> For donation use this link: >> https://www.repetier.com/download-software/Done  I was already on this page and didn't donate at that time because I only saw credit cards logos, and didn't want to enter my cards details I admit I was…
  • That did the trick, thanks  My new setup:  Alpha A  210.500  Alpha B  329.500  Alpha C   90.500 This is my Delta printer calibration workflow:  - M322 S3         Reset auto level matrix permanently  - G33 R0           Delete distortion map  - G28  …
  •  Thanks for your for your prompt response>> changing b or c angle will help hereJust to make sure, are you referring to Alpha A, Alpha B and Alpha C parameters ??Considering the specific area to trim, which angle should I try to adjust first ?…