› ›

AKI

About

Username
AKI
Joined
Visits
11
Last Active
Roles
Member

Comments

  • If needed I can also give you my configuration.h if it will help tremendously.
    in No Start Signal Comment by AKI September 2017
  • Repetier said: What firmware? In repetier-firmware baud rate is stored in eeprom so configuration.h value can be overwritten. Just try the typical ones to be sure (115200, 250000). If not make sure printer is using that port and not an other …
    in No Start Signal Comment by AKI September 2017
  • Repetier said: You would receive such noise if the baud rate is set wrong. So firmware or host has now a different baud rate set for some reason. I have checked multiple times to see if the baud rates of the firmware, as well as the host, a…
    in No Start Signal Comment by AKI September 2017