dagn
About
- Username
- dagn
- Joined
- Visits
- 38
- Last Active
- Roles
- Member
Comments
-
Motors do not respond to commands from this firmware. The commands from 0.92.9 respond. The truth is that in P-H in other control programs like Simplify3D 4.0.0 the extruder motor is not controlled. Repair this moment. Because with firmware 1.0.0 do…
-
as I understood as soon as I send it home, due to the absence of the Motov reaction, and accordingly there is no data from the endstop, P-H 2.0.5 pending the execution of the command sequence.
-
The error does not go away. Formed a new firmware in the configurator. The error was gone. But now, when connected, the printer is busy processing. motors do not respond to commands 07: 50: 07.171: Using fast VBOs for rendering is possible 07: 50:…
-
When the printer is connected, a fatal error occurs. http://prntscr.com/gekgv5
-
At you on a site there is a link only on 0.92.9 and there on stable 0.91 rv8 Please send a link to the new firmware. At 0.92.9, I have another problem, sometimes on some layer something strange happens. Printing does not follow a toe-one, but as i…
-
The error still remains.
-
Repetier said: Most are just warnings about redefinitions and can be ignored, or you use dev version where we fixed them. pins.h:374: error: 'PS_ON_PIN' was not declared in this scope is the only error meaning your board did not set the pin…
-
I'm trying to translate to another firmware but I can not find the pin numbers in the Repetier-Firmware to turn on the table heating and bed temperature sensor. For some reason, the user file does not have this data, and the board manufacturer…
-
Then it's in your firmware. And stable version 0.91 rv8 produces an error when compiling: Arduino: 1.8.3 (Windows 7), Плата:"Arduino Due (Native USB Port)" In file included from sketch\Configuration.h:42:0, from sketch\Repetier.…
-
Repetier said: Circles are printed as lines even if using G2 or G3 - just then firmware needs only one command and can reduce it to smaller lines. Instead, but most slicers śdo not generate these codes at all. Your extruder problem is either…