Freak
About
- Username
- Freak
- Joined
- Visits
- 20
- Last Active
- Roles
- Member
Comments
-
I'm confused as to what should be changed here? It looks like there's different boards available to use but I can't find mine on the list? (MKS base v1.5 control board). Also would say with your current knowledge, and with what you'd do, is it sa…
-
Is there a way I can edit this with Repetier Host instead of the firmware? I know someone who had a K200 and he too switched from E0 to E1 but he said he didn’t touch the firmware. I’ll find HEATER_2_PIN in 30min
-
I see what you meant by config tool. I just opened up the original Firmware for the board and am looking at the firmware. What do I. Need to edit to switch from E0 to E1 for the extruder? Do I need change anything else or that’s it?
-
Wait in config tool? Wouldn’t it be in the firmware? And I tried looking in config tool and couldn’t find an option. Not sure what I’m looking for. If I did switch the option to use a different pin from E0 to E1, would electricity still ru…
-
Forgot to add this here too https://imgur.com/a/4uisL
-
So while trying to replace the fan, two wires touched accidentally and it fried the fan/wires. While taking a closer look at the board, I saw this The transistor (third one on the right) got blown and the wires for connecting to the board for the …
-
Looking back at the board, I just want to confirm this so I wouldn't have to worry about it; according to the wiring diagram it seems like it doesn't matter which ends on the heating pipe wires are + or - (Even though on the board it does specify w…
-
Thanks, I took apart the fan and the motor was bad. Wiring was good, so I am ordering a spare. I'm hoping it's some coating. I didn't have any material inside of the extruder. Is it okay to turn on my extruder to 200C for 5-10min without the extru…
-
I got it, but whenever I heat the extruder to 200C it starts smoking/fan isnt turning on. Could it be smoking because its the first time? But that doesnt answer the fan
-
Nevermind
-
So whenever I tell the printer to move down 1, it just keeps going down until I have to cut the power. Any ideas why?
-
My bad, I’m not using Marlin. I’m using repetier firmware.
-
Do you know any tutorials on how to adjust the steps per mm for a delta printer?
-
Repetier said: That doc is for repetier-firmware that you build yourself. On a bought machie I would expect that they have confugred it already correctly so you can simply run the leveling commands for the used firmware (differs in code). …
-
Ah great that worked, thanks! Now, there's a situation I'm in if you don't mind. We just switched from using OctoPrint to Repetier, along with the Marlin firmware to Repetier firmware. We tried to set it up properly, but when we home it it gives me …
-
Sending the G-Code worked perfectly. And I don't understand #2. Do I set "Home Z:" to the height, in mm, from the bed to the end stops? And when you say printer height, I assume you mean "Printable Height"? We originally had OctoPrint as our host,…