robinsonjas
About
- Username
- robinsonjas
- Joined
- Visits
- 22
- Last Active
- Roles
- Member
Comments
-
K, have played with the printer for a few days off and on. I think it was not incrementing E. If I run a print job it will extrude but I had issues w/ Z height - too close to bed so was grinding. Finally got bed level & autolevel config correct …
-
Even if I had previously did a G1 E20 F200?? I figured the extruder would be primed and ready since it had just pushed out 20mm
-
I can tell you my command was G1 X100 E20 F200
-
Thanks for help... Will test when I get back in town and update you