bread_bird
About
- Username
- bread_bird
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
Awesome, the M502 is super helpful. Thanks all for the information!
-
Sure enough it was the EEPROM values that were causing the error. I figured out how to set the Z max value, and now the printer comes to a stop when it should. I remember on my Marlin firmware, you could change the configuration.h file and it would …
-
I have switched to Repetier-Host just to make sure it isn't a host issue. I homed the z axis, and as the axis moved it showed the position as 95mm. Then it hit the endstop, at which point it jumped to 300mm again. I pressed "set home" and position w…
-
Unfortunately this is preventing me from printing files. Homing to the endstop works correctly, but the printer still thinks it has to move 300mm before the print starts.
-
Sorry, should have clarified; I am using Cura, and I don't see a setting similar to the one you mentioned. I was under the impression that you could use a Z max endstop regardless of the host you used. Would I have to use Repetier-Host for this conf…
-
I was talking about what the firmware shows after I request the toolhead position. I have the Z height set to 95 in the host as well.