Stevenlgts

About

I believe my problem is similar except to VinnyVG's except my A8 is printing 5-10mm too high.

in Using Repetier by USB cable to Anet A8 - my extruder prints 20mm to high Comment by Stevenlgts June 2017
I agree there is some kind of scaling setting that is not set right in the firmware. I have tried several times redoing the firmware with no improvement. I have replaced the nozzle and adjusted the bed. I have also tried printing from the sd card wi…

in Z-axis off.. printing stringy Comment by Stevenlgts June 2017
Found the problem. It has to do with the M117 command. Here is what Repetier recommended: "Here it seems the M117 command confuses the firmware. I guess it is the same in case 1 also we do not see it but line 37 seems also a M117 command. So my gue…

in Problem starting a print Comment by Stevenlgts June 2017
I was having the same problem with the error due to retraction and I deselected the "Send to ETA to print display" and it correct my printing problem!

in [repetier host 2.0]Print stopped soon after begin on micromake D1 Comment by Stevenlgts June 2017