› ›

Dawido

About

Username
Dawido
Joined
Visits
31
Last Active
Roles
Member

Comments

  • Perfect, thank you Mr. RAyWB, after setting UI_BED_COATING to 0 and ZHOME_HEAT_HEIGHT to 0 printer starts to doing what I wanted it to do, even I did some Z probe height calibration and its looks like all is working: READ: EPR:3 153 123.271 Z max le…
    in Z probe and Z max Comment by Dawido June 2017
  • Ok, Z_MIN_POS set to 0,  without G32 S2 it is wrong, so to sum up, after doing Z home for Z max 125 it is doing it 5mm above bed, after Z home when going to Z0 it is going something like 6-7mm lower, 131-132mm (1mm into bed), so there is something w…
    in Z probe and Z max Comment by Dawido June 2017
  • Hi, Z_MIN_POS -10 was used for Z_PROBE_HEIGHT setting/calibration after first G32 S2 (that's why I did not stated exact measured Z max length), I will change it back to 0 as you suggested and will check result this afternoon, in meantime please fi…
    in Z probe and Z max Comment by Dawido June 2017
  • Ok, downloaded whole firmware again and just copy-past configuration.h file, that solved this issue.
    in Invalid operands Comment by Dawido June 2017