› ›

Clarence

About

Username
Clarence
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Hi Repetier, Actually I am using another file for extend the pin.h define So, it's "ramps6.h" for example. I don't have a compile error actually.Other num_extruder works fine, or If I set FEATURE_CONTROLLER 0. All NUM_EXTRUDER from 1~6 works too. On…
    in Mixing Extruder Comment by Clarence December 2014
  • Hi Repetier, I am trying to extend RAMPS 1.4 to 5 or 6 mix extruders. But somehow, compile pass but when Arduino 1.5.6-r2 upload to board till almost done. It hangs there when NUM_EXTRUDER 5 + FEATURE_CONTROLLER 2 But NUM_EXTRUDER 6 + FEATURE_CONT…
    in Mixing Extruder Comment by Clarence November 2014