caslor
About
- Username
- caslor
- Joined
- Visits
- 44
- Last Active
- Roles
- Member
Comments
-
Thanks
-
Ok i found in one forum something similar and the solution is to use M400 command before each of the commands that were executing earlier than they should . ( M400: Wait for current moves to finish ) So with this code everything worked f…
-
Unfortunately it doesent work with the short file names... as it is the .gcode extension.. But this is something not so necessary so i am happy that i found the solution to print from sd card with .gco extension i love the repetier hos…
-
Ok i found what i was doing wrong i was trying to print a Gcode file from sd Card (.gcode) and seems that firmware cant do that i saved my file from repetier host as ''Save for SD print'' and i manage to print the file from SD card the f…
-
Hi and Mery Christmas to everyone Still cant make it work with Sd card I tried different sd cards i had but still nothing...
-
Hi again... i tried all above but nothing changed i can print through repetier host but the printer cant print from Sd card here is the log file from 2 attempts i tried today 12:35:33.120 : File opened:ex28byj_fila.gcode Size:1705140 12:35:3…
-
Ok thanks for the super fast answer i will try all these you suggested me to see what was wrong... thanks
-
thanks
-
Ok i find a solution in order to make it work i had to change in each line of code the letter of the extruder from A to E in my first attempts i changed the ''G92 E'' to " G92 A'' but it didnt work.. so had to change all the code …
-
Thanks for the help even i dont have any background of studies in programming i manage to find the right file and alter the code now thanks to your help the repetier host can read the values this is a post for feature reference if any one h…
-
and here is what i am getting in repetier log when i place a target temperature for the extruder (without having connected the heater element, that is why the temperature doesnt rise up ) '' 10:28:18.778 : ok 10:28:20.670 : N17 M104 T0 S200*21…
-
This is the result from pronterface when i send M105 ''>>> m105 SENDING:M105 T:21.50/0.0 '' and here if i place a target for the hotend '' Setting hotend temperature to 185.000000 degrees Celsius. >>> m105 SENDING:M105 T:2…
-
Hi This is from the log in Repetier-host. As i can see it can read the temperature right in the log but doesnt display it in the ''manual control'' graphic panel where the extruder is '' 08:21:55.440 : start 08:21:55.552 : N1 M110*34 08:21:…
-
As I can remember (I am not in the pc right now to confirm it) it doesn't return nothing.. Also I remember that when I connect the board to Repetier-Host it says bad M command 111, bad M command 80 bad M command 20 I will check…
-
Thank you very much... you are my saver i had tried to remove the files in ./home/caslor/.local/share/RepetierHost but had no luck.. didnt know that the files was also stored in the /home/username/.mono/registry/CurrentUser/software/ thank…