DonParpan
About
- Username
- DonParpan
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Yeah. Thanks a lot.
-
Thanks for that answer! So simply get the analog thingy, hook it up to power and ic2 ports and laser, and use the custom events, right? What about the rest of that code? Can I just leave it in? Do I need to do anything else? I have no clue what I'…
-
I don't have one. All I know that it has 12+ gnd and a 0-5V for control. I can figure out if It runs better on analog or pwm myself. My question is if both boards are needed for it to run.
-
I simply don't understand the problem, that's it. Guess I'll need that solution then. But that raises another question. There are two Laser wires. One analog and one pwm. Does that mean it would work if I were to use only one of those? My knowledge…
-
Maybe I'll have to do that. It's a stupid solution though if you ask me. I have more than enough free pwm pins.
-
I have one that should work with up to 20kHz. Also have a weaker one that is pwm"able" Both don't like the software pwm very much.
-
Sorry, but I can't find anything that makes sense to me. Might be black magic for all I understand. Guess I won't have pwm then...
-
Yeah...thanks. But that's not what I am looking for. I have everything I need. All I don't have is the knowledge on how to use the Sxxx after the command to write a pwm signal.
-
Like said, looks like I have more than enough useable pwm pins, one of them the fan. And I have the laser mode enabled. I just don't use it because of the limitations of the software that seems to work with it. It would be really nice if i could ge…