ralfsteck

So I can at least save the Slic3r data? That would help alot.

in Obtain Settings from Backup? Comment by ralfsteck November 2020

Yes I know, but I wonder why the software endstop options are missing in the configuration tool.

in Printer running over Endstops Comment by ralfsteck July 2016

Yes I upgraded, but you're right, the endstops are diesabled after homing. Makes sense. And what about the software endstops?

in Printer running over Endstops Comment by ralfsteck June 2016

Ah, OK, I'll try that. So the right procedure would be e.g. G28 G1 Z30 G32 S2 ?

in Extruder going too high while probing Comment by ralfsteck June 2016

Hi Repetier, may I place a question, please: You just said that with G32 S2 it's not necessary to do Bed leveling before every print (that's logical to me). Now people tell me that a Z homing overwrites bed leveling (which seems implausible to me).…

in Help with Z-probe in Repetier firmware Comment by ralfsteck December 2015

#define EXT0_WAIT_RETRACT_UNITS 3870, in the Repetioer configurator it's 3mm. Rep V92.4.

in Extruder motor goes crazy Comment by ralfsteck September 2015

in Printer crashes on Z homing Comment by ralfsteck July 2015

The Z motors stay on after the crash

in Printer crashes on Z homing Comment by ralfsteck July 2015

Funny, I worked on V92.3 sources from June, 4th, 2015. Downloaded everything and compiling went OK now, though. Thank You for the superfast reply. Cheers, Ralf

in #error MAX_HALFSTEP_INTERVAL must be greater then 1900 Comment by ralfsteck July 2015

How can I append my config here? Dropbox? Here's the link: https://www.dropbox.com/s/g7jhgwb6b2jmtl7/Configuration.h?dl=0

in #error MAX_HALFSTEP_INTERVAL must be greater then 1900 Comment by ralfsteck July 2015

I switched to Repetier Firm 0.92 and never had that problem again.

in Printer looses temps at start Comment by ralfsteck January 2015

So that was a wrong assumption of mine, I thought it would work that way. Never tried it in reality.

in Z-Level and Zmax Comment by ralfsteck January 2015

Maybe I should add that I urgently want to come back to Repetier firmware as the meus are way better :-)

in Printer looses temps at start Comment by ralfsteck November 2014

Hi, I'm one step further: I switched to Marlin firmware and the problem is gone. So it must be a (I suspect a configuration) problem with repetier. Is it OK to upload my configuration.h here so someone with knowledge can have a a look?

in Printer looses temps at start Comment by ralfsteck November 2014

Isn't that what you were looking for: > 15:19:57.134 : T:30.42 B:104.44 B@:255 @:0 > 15:19:57.930 : Echo:M190 S105 > 15:19:57.930 : ok 41358 > 15:19:57.930 : TargetExtr0:235 > 15:19:57.930 : Echo:M104 S235 > 15:19:57.930 : ok 41…