ptab

Comments

• > it only set the first (at 500) position and moves anymore during the execution.  So xy moves do not work when servo is enabled? Do commands still get send? Anything in log? I think your sentence is likely to be misunderstood.Thank you! I solve…

  in Servo doesn't work after launching print Comment by ptab May 2017
• this is my configuration.h

  in Servo doesn't work after launching print Comment by ptab April 2017
• Steppers on X/Y/Z move perfectly. I tried to perform a drawing and everything goes fine apart from the servo motor. The machine is programmed to reach a x/y/z position, at that point it should open, grab a tool and go back to the drawing, but this n…

  in Servo doesn't work after launching print Comment by ptab April 2017