› ›

kwalters35

About

Username
kwalters35
Joined
Visits
4
Last Active
Roles
Member

Comments

  • The slicer assumes that T0 is the current extruder being used by the printer, but the printer will remember the last used extruder from the previous print until reset or power cycled.  I added a tool change in my end g-code to set the extruder back …
    in Dual extrusion - wrong first layer Comment by kwalters35 April 2017
  • I have a sainsmart version of the reprap full graphics running on my corexy with repetier.  I connected to the LCD connector using the sparkLCD adapter settings and pinout, but had to add 1kohm resistors to the RS,EN and D4 connection to get anythin…
    in RADDS Board with Full Graphic Reprap Clone Comment by kwalters35 April 2017