mgd
About
- Username
- mgd
- Joined
- Visits
- 26
- Last Active
- Roles
- Member
Comments
-
Thanks for that.
-
Hi Sunhokey have sent me - 1 arduino 1.6.6 RAR File 2 Configuration H File 3 Steps for flashing the main board. File folder 4 Marlin File Folder What do I do with these? (I would have attached them so you can see but I can't find any w…
-
I will see if I can get the un-compiled firmware from Sunhokey. Thanks
-
Hi Martin I have been using the printer since 2015 successfully but when calibrating for instance the Esteps are set at 80.5 and should be 96. I have been changing it by the lcd screen each time I switch on. I believe I can avoid this if I chan…
-
Cut red and blue wires on the x axis stepper motor, swapped them over and the printer worked. What mystifiers me is that all the motor plugs on the board are keyed but I know I didn't disconnect any plugs or wires. C'est la vie! Well anyway thanky…
-
I'll try that, thankyou
-
MartinH said: Did you unplug the X motor at an y time when you were doing your mods. Reversing the motor connection will reverse the rotation direction No I didn't disconnect any wires, only unbolted the x end stop. Now when I switche…