› ›

kini

About

Username
kini
Joined
Visits
1
Last Active
Roles
Member

Comments

  • Repetier said: This is just because from old steps you saw 3.7 times faster. If you increase extrusion speed it will again look that fast. But in print speed is adjusted by slicer speeds so nothing to worry about. Solved. I've accidently set…
    in Filament pressure Comment by kini April 2017
  • MartinH said: When you tell the printer to extrude 100mm, this is the amount of filament going into the hot end,  not how much is coming out of the nozle. Yes, I known that and that is what it does. The problem is that its coming out o…
    in Filament pressure Comment by kini April 2017