HenryLoenwind

About

Username
HenryLoenwind
Joined
Visits
1
Last Active
Roles
Member

Comments

  • 10 or 20? I see a difference of 17 between the first measurement (which is taken from whatever height G30 chooses) and the rest (which are taken from the height Repetier-Host send in the G1 command, 50 in this case). And there's is a difference betw…
  • ok, I think I got it. I replaced the bltouch with a micro switch on the nozzle for calibration. The value for the escher calculator is the G30 value minus 32. No idea why, but that works. Now I have this: X: -60.00 -46.67 -33.33 -20.00 -6.67 6.67 …
  • Again, how do I convert the G30 reading into "Nozzle height error" for the escher calculator? Or can I use that calculator at all with this probe (47mm offset)?
  • Um, how do I convert the G30 reading into "Nozzle height error"? I'm quite sure my A tower is not 20° off... Here's the height map: http://i.imgur.com/yYZjQnM.png Doesn't tell me anything.
  • Oh, height map. I read about that before, never seen it in the program......ok, found it. Ran it. Got the nozzle rammed into the bed. (At least it was cold...) Update: Strike this, I had the print radius still at 88 instead of 90.
  • Yeah, I noticed G33 being rather destructive on my Delta, too. It's ok on my cartesians, there the grid can easily be configured onto the build plate. Also, measuring in a r=16mm circle isn't helping at all---that's how much is left after I have to …
  • Repetier said:  not calibrated z min endstop whcih stops at a compületely different and unknown height Isn't that exactly what z-leveling is supposed to do? Measure the offset between the endstop and bed surface? I had a quick look, and …