harristhepoodle
About
- Username
- harristhepoodle
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Repetier said: Great it is working now. What? no it doesn't, I'm slicing it with slicer with start and end Gcode, but doesn't actually print, but prints apperently on the software
-
Repetier said: "proceeds to print, but just on the firmware, while the printer is doing nothing" So are you now printing a gcode or not? That is a contradiction to me. Setting temperature in manual control uses different commands that return…
-
Repetier said: Check if you can still send commands like M115 and see response in log. It might be that firmware is stuck waiting for target temperature which would be a classic startup problem when printer is not configured correctly. You mu…
-
Repetier said: In our online config tool or configuration.h directly. what do i need to change?
-
Repetier said: Look earlier in the log. Your extruder seems to trigger the decoupled test. So it is either configured wrong or it heats slower then assumed and you need to increase decouple time for that. Log should show more info at the time…
-
MartinH said: does the hot end and bed heat up correctly if you turn them on in the host Yep, When I print they heat up
-
Repetier said: Test if firmware is configured correctly with M119 which shows endstop status. Test manually to see if it changes. For example if you home x to left you must have z min endstop triggering at that side. How can I configure …
-
Repetier said: You must configure this in your firmware. there is a invert option for every axis. Alternative rotate motor connector 180° which also inverts direction. where to configure?