Aravindkannan
About
- Username
- Aravindkannan
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I set 400 steps per mm for x and y, and 800 for z axis I have jumper configuration for pins 1=yes ,2=yes,3= yes for xyz and extruder and this is the eprom config below config has default steps per mm i have changed it as above …
-
I changed the steps per mm increased the current this is what i am getting in the log 21:47:48.574 : wait 21:47:49.508 : Printer reset detected - initalizing 21:47:49.508 : start 21:47:49.525 : Transformation matrix: 1.000000 0.000000 0.000000 0…
-
I changed the steps per mm increased the current this is what i am getting in the log 21:47:48.574 : wait 21:47:49.508 : Printer reset detected - initalizing 21:47:49.508 : start 21:47:49.525 : Transformation matrix: 1.000000 0.000000 0.000000 0…
-
No it doesn't do anything I keep getting these wait commands over and over again and when I tried to move the axis there is a noise coming from ramps or maybe from motor s I can't tell
-
After setting the baud settings to 115200 the printer makes a noise when I tried to move the axis but doesn't move
-
I tried 115200 but in the log I am getting Wait Wait Ok 152 T:180.30/200 @:255 The number keeps changing in the manual control it alternates between heating extruder and idle